Stop and Go

Fragment of a discussion from Talk:Basilisk
Jump to navigation Jump to search

Maybe I should move the stop and go into the onScannedRobot event instead of its current goTo void. Currently I am using prevEnergy > enemyEnergy, with enemyEnergy being called every tick and prevEnergy being called right after moving. If I move it into the onScannedRobot event, and use prevEnergy > e.getEnergy(), do you think that would fix some of its problems? Thanks!

Slugzilla (talk)‎22:25, 9 April 2019

As long as you are checking if delta energy is between 0.1 and 3.0 there shouldn’t be any problems. I think that your current system of upgrading enemy energy is working but I’m not sure.

Dsekercioglu (talk)‎22:35, 9 April 2019

Currently I am just checking if the energy drop is greater than 0.1. I'll add a 3.0 segment later to fix that up. By the way, congratulations on Partial getting #23! The race is neck to neck =)

Slugzilla (talk)‎23:34, 9 April 2019
Oops, you might want to use 0.099 < e < 3.01. Sometimes energy 3.0 and 0.1 won’t be detected.
Partial is using Simonton’s PM Gun so there is a lot to improve. You might have noticed its low Pwin. I am prettt sure Basilisk will enter top 20 when the bug is fixed though.
Dsekercioglu (talk)‎05:51, 10 April 2019

Oh sorry, i misspoke. I check if the energy drop is greater than the previous energy, so 0.1 should register. Are you going to add on to the PM gun or maybe try out a guessfactor gun?

Slugzilla (talk)‎22:34, 10 April 2019
 
 
 
 
Retrieved from "http://robowiki.net/wiki/Thread:Talk:Basilisk/Stop_and_Go/reply_(8)#Stop_and_Go_6553"