Rumble Client
Hi Skilgannon,
There is nothing special. Rumble clients runs with a stock config, where only user name is set and I exclude Lo_Ian.Gandalf_V4*, since it seems to halt on my side. This 6 CPU machine, but only 2 are heavily used for roborumble and meleerumble clients, though last week I left It unattended and firefox start to consume a lot of load, so may be it somehow skewed CPU constant of the client.
If you have some ideas what could it be, I will be happy to investigate.
Things often brought up in rumble client discrepancy cases are which OS is in use, and what exact version of Java is in use.
Also, other possible relevant factors are:
- If CPU frequency scaling is enabled, as it is by default on most newer machines (this can cause problems for robocode's CPU time limiting being fair)
- If the system in question has high memory usage such that it goes into swap space.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page.
FWIW I don't think anybody's measured the effect of dynamic clock speed on skipped turns, only speculated that it should have an effect. For all I know, the timings coming from Java on modern CPUs could have so much variance that the dynamic clock speed doesn't increase the number of skipped turns that much.
Here I run a single client with blank config for a while so it calculates CPU speed alone, before dynamic clock kicks in. Then I copy config to all clients and run them in parallel.
The effect is they assume a worst case in CPU speed and skipped turns occurs less often than it should. Which I think is better than occurring more often than it should.
Thanks for the offer. Could you test DrussGT 3.2.1 vs. Garm, Shadow, Hydra and Gilgalad? Functionally, 3.2.1 should be almost equivalent to 2.8.16 (3.2 has 3-series bullet shielding disabled), but as this comparison shows they are getting very different scores.
There are also a few bots DrussGT now gets 100% against - this worries me, as it points to them crashing.
What should be the setting on a client to perform such test? Or should I use RoboRunner?
Also my observation showed that sometimes short test set shows drastically (1% APS) higher scores. I was fulled by it couple times thinking that my older bot is more superior to a new version. They end up to have the same score or even reversed as I keep waiting for stats accumulation.
I compared DrussGT Version 2.8.16 to DrussGT 3.2.1 And 2.8.16 was way better http://www.2shared.com/photo/bKABJFb4/2816_vs_321.html