Anti-Surfer Targeting

OK, now I understand. I was afraid that I had a big flaw in the algorithm that made it slow. What I learned is genetic algorithm always works better than manual tuning in the long run. What I do when it ends is to roll the numbers that are really high and low to the max/min values and then I get about a 1% boost in score which easily surpasses the hand tuning. Since only my GA is multi-threaded hand tuning is a little slower too.

One final question, where do the files I save go on RoboRunner-GUI? I didn't even test(Std Me) before putting WhiteFang against 28 surfers for 10 seasons then I accidentally compiled the project(Me again).

I don’t use GUI. The recorded files are located in each robocode installation, inside regular data file location.

I’m trying GA then. I’m tired tuning anti-random gun by hand, because tuning for one set of data decreases performance against another set of data (1500 battles should be enough, but it’s not the case when all your improvements are below 1% hit rate)

I have even tried sorting by "last modified" and "last created" but nothing seems to have appeared. I am still getting data files with the development version though. Can't test the packed one because of the bug in 1.9.3.5.

Edit: .data was a hidden directory. command + shift + . solved all the problems.

Update: after some profiling, it confirmed that kd-tree is the only bottleneck.

However, it seems that file reading time grows as kd-tree time grows.

And after putting deserializaion into separate thread and use some producer-consumer pattern to communicate, total run time stays the same and file reading time decreased greatly. Maybe my profiling tool is yielding inaccurate result.